[ICEM] ICEM CFD internal Wall by using structured Grid -- CFD Online Discussion Forums

June 30, 2010, 05:26	ICEM CFD internal Wall by using structured Grid	#1
challenger85 New Member Torsten Thomas Betschart Join Date: Nov 2009 Posts: 10 Rep Power: 16	Hi All How is it possible to introduce an internal wall to a structured grid (coming from a 3D blocking)? Normally, I perform the following steps: 1st. Create the Blocking 2nd: Convert the Mesh from the calculted Pre-mesh to an unstructured mesh. Normally, one could use the option int wall in the Part Mesh Setup, which I tried several times: but in this case, it just didn't work with this comination I told. Does somebody know, how one can get over these Problems? Best regards Challenger

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Unstructure Meshing Around Imported Plot3D Structured Mesh ICEM	kawamatt2	ANSYS Meshing & Geometry	17	December 20, 2011 11:45
Shadow wall in ICEM	Reine GranstrÃ¶m	FLUENT	2	October 13, 2007 04:07
Can I specify boundary conditons in icem cfd	Harry	CFX	6	April 5, 2006 12:10
Multicomponent fluid	Andrea	CFX	2	October 11, 2004 05:12
ICEM CFD Modules	Boris	FLUENT	1	March 12, 2004 14:37

All times are GMT -4. The time now is 15:10.