|
[Sponsors] |
Fail to create skin from imported spline (.stp) into DesignModeler |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 13, 2011, 01:19 |
Fail to create skin from imported spline (.stp) into DesignModeler
|
#1 |
New Member
Join Date: Apr 2011
Posts: 11
Rep Power: 15 |
Hi,
I have successfully imported spline from .stp file into DesignModeler (attached pic) via import external geometry file. However, I couldn't find the next step to turn these spline into lines for Skin/loft function. Any suggestion would be much appreciated. |
|
June 13, 2011, 02:52 |
|
#2 |
New Member
Join Date: Apr 2011
Posts: 11
Rep Power: 15 |
Found the answer in the old thread. Thank you for your attention.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Spline in DesignModeler? | Edu-R | ANSYS Meshing & Geometry | 1 | April 4, 2010 18:04 |
Actuator disk model | audrich | FLUENT | 0 | September 21, 2009 07:06 |
How to create a variable-pitch helical sweep in Designmodeler (v11.0) | dgasperi | ANSYS Meshing & Geometry | 0 | August 13, 2009 13:11 |
Where's the singularity/mesh flaw? | audrich | FLUENT | 3 | August 4, 2009 01:07 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |