cut a face on a volume (real)

lili · September 13, 2011, 03:07

hi max
the pic attached is a spray dryer chamber that hot gas enters it from a ring hole on top of it. I want to creat a ring enterance on the top. is it clear?

-mAx- · September 13, 2011, 04:35

do you just want to isolate an annular face on the top face?

lili · September 13, 2011, 05:54

no. the annular face must be a part of the total volume and it must be meshed. I want to enter air from it in the chamber.

-mAx- · September 13, 2011, 05:58

so you want your top surface divided with a circle, which will describe your annular, right?

lili · September 13, 2011, 07:00

yes. on the top surface there is a ring from it hot gas enters the chamber.

-mAx- · September 13, 2011, 07:10

create the circle (edge), move it at it right position, and then split top surface with circle

September 13, 2011, 04:35		#2
-mAx- Super Moderator Maxime Perelli Join Date: Mar 2009 Location: Switzerland Posts: 2,280 Rep Power: 24	do you just want to isolate an annular face on the top face? __________________ In memory of my friend Hervé: CFD engineer & freerider

September 13, 2011, 05:58		#4
-mAx- Super Moderator Maxime Perelli Join Date: Mar 2009 Location: Switzerland Posts: 2,280 Rep Power: 24	so you want your top surface divided with a circle, which will describe your annular, right? __________________ In memory of my friend Hervé: CFD engineer & freerider

September 13, 2011, 07:10		#6
-mAx- Super Moderator Maxime Perelli Join Date: Mar 2009 Location: Switzerland Posts: 2,280 Rep Power: 24	create the circle (edge), move it at it right position, and then split top surface with circle __________________ In memory of my friend Hervé: CFD engineer & freerider

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to set periodic boundary conditions	Ganesh	FLUENT	12	April 10, 2013 00:44
channelFoam for a 3D pipe	AlmostSurelyRob	OpenFOAM	3	June 24, 2011 13:06
Import problem	ARC	Open Source Meshers: Gmsh, Netgen, CGNS, ...	0	February 27, 2010 10:56
gmsh2ToFoam	sarajags_89	OpenFOAM	0	November 24, 2009 22:50
[GAMBIT] Difference between real & virtual line, face, & volume??	teguhtf	ANSYS Meshing & Geometry	2	October 5, 2009 07:47

September 13, 2011, 05:54		#3
lili Member leila Join Date: Jul 2011 Posts: 35 Rep Power: 3	no. the annular face must be a part of the total volume and it must be meshed. I want to enter air from it in the chamber.

September 13, 2011, 07:00		#5
lili Member leila Join Date: Jul 2011 Posts: 35 Rep Power: 3	yes. on the top surface there is a ring from it hot gas enters the chamber.