|December 1, 2011, 07:17||
Interphase boundary condition
Join Date: Dec 2009
Posts: 23Rep Power: 6
I am modelling an air nozzle inside a pipe with 2D axisym geometry. To obtain nice mapped mesh, I have meshed the edges of the nozzle and assigned each of them a boundary condition. But if I use interphase BC for nozzle exit, I get errors in Fluent (Unassigned interphase zone detected). I would like that Fluent calculates variables at nozzle exit
Can anyone explain to me why I do get such error?
Should I remove the nozzle exit edge and work on mesh?
Thank you very much for your help
|Thread||Thread Starter||Forum||Replies||Last Post|
|Boundary Conditions||Thomas P. Abraham||Main CFD Forum||20||July 7, 2013 05:05|
|Can anyone give me some hint on how to make traction free boundary condition?||poplar||OpenFOAM||2||May 16, 2013 03:02|
|Setting outlet Pressure boundary condition using CAFFA code||Mukund Pondkule||Main CFD Forum||0||March 16, 2011 04:23|
|Domain Imbalance||HMR||CFX||3||March 6, 2011 20:10|
|How to set boundary condition in Fluent for the fo||Peiyong||FLUENT||1||November 10, 2006 11:44|