|September 16, 2011, 02:38||
Saving the 'Table of Design Points'.
Join Date: May 2011
Posts: 12Rep Power: 7
I have input and output parameters in my ANSYS Table of Design Points - work fine - but would like to print out that table, either in a report or elsewhere.
Sure I can do a screen print or copy it out but what the @#$^%^.
I can't believe I'm the only one that would want a concise table of inputs and outputs delivered by ANSYS without human typesetting errors and the only alternative I can see is to print out obviously repetitive and voluminous @#$%&#^$ in standard result reports for each design point.
Any help/advice please?
Last edited by rae; September 16, 2011 at 02:40. Reason: need help
|Thread||Thread Starter||Forum||Replies||Last Post|
|Importing Points in Design Modeler||danh||ANSYS Meshing & Geometry||5||March 30, 2015 10:45|
|How to Connect Points in Design Modeler to make airfoil profile (2D)||andrew_diablo||CFX||2||November 12, 2012 06:28|
|design table||Nick Sessions||FloEFD, FloWorks & FloTHERM||0||October 7, 2008 16:00|
|BlockMeshmergePatchPairs||hjasak||OpenFOAM Native Meshers: blockMesh||11||August 15, 2008 07:36|
|Info: Short Course On Thermal Design of Electronic Equipment||Arnold Free||Main CFD Forum||0||August 10, 1999 10:18|