|
[Sponsors] |
May 22, 2013, 09:09 |
conversion of geometry
|
#1 |
New Member
Join Date: May 2013
Posts: 1
Rep Power: 0 |
Hi all.
I need to convert a solid exterior model to the inside fluid model, to prepare a CFD simulation. For an example this could be the geometry of a heat exchanger, which needed to be converted to the fluid model within the heat exchanger Does anybody know how to do this in autodesk inventor? Best Regards Thomas |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem Importing Geometry ProE to CFX | fatb0y | CFX | 3 | January 14, 2012 19:42 |
Reg difficulties in meshing the geometry...Urgent | arunraj | ANSYS Meshing & Geometry | 0 | August 26, 2011 23:25 |
2D geometry to 3D geometry | Sgonzalezg | ANSYS Meshing & Geometry | 11 | April 8, 2011 11:02 |
[ICEM] B-Spline, Faceted, kernel | Mario-CFD | ANSYS Meshing & Geometry | 1 | December 23, 2010 14:15 |
[snappyHexMesh] SnappyHexMesh meshes inside and outside of an STL geometry | villier | OpenFOAM Meshing & Mesh Conversion | 17 | June 15, 2010 19:51 |