|
[Sponsors] |
June 14, 2001, 07:17 |
Arbitrary Matching & Partial Boundaries
|
#1 |
Guest
Posts: n/a
|
I call upon the forum for some well-needed advice with regards to partial boundaries in Star-CD 3.1.
I'm trying to match a semi-circular surface with a larger rectangular surface for the purpose of modeling an air handling unit. At the interface, the cells are approximately 1" cubes on either surface (except for the outer portion of the semi-circle, where the aspect ratio is slightly larger). The problem is as follows: I apply partial boundaries before implementing the arbitrary match command, yet I have cracks in the model at the partial boundary interfaces (indicating to me that the cells are not matched). Then, when I apply partial boundaries again in order to get these specific cells to match, my crack problem is solved, but there is no more partial boundary (i.e. there are holes at the interface). Any suggestions? Kindly help a Star-CD rookie in need... |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
matching arbitrary meshes | oulebsir redouane | Main CFD Forum | 5 | July 18, 2006 04:06 |
[Q] UDS flux matching by using UDF | Jekin | FLUENT | 0 | May 17, 2005 01:35 |
Cyclic Boundaries -> Match Option -> Arbitrary | Derek | Siemens | 1 | August 4, 2004 22:06 |
Edge matching | Jens | CFX | 3 | March 14, 2002 12:37 |
CYCLIC BOUNDARIES MATCHING | robert | Siemens | 3 | September 7, 2000 01:08 |