Home > Forums > CD-adapco

Meshing in StarCD

Mark Forums Read

Reply

December 9, 2001, 14:17	Meshing in StarCD	#1
anindya Guest Posts: n/a	How can I create a boundary layer mesh using prostar ? I am modeling a 2D axisymmetric (I am using cylindrical coordinate system, with just 1 divison in theta direction) jet where I want a finer mesh near the impingement wall and also near the jet exit. Thanks

December 10, 2001, 03:25	Re: Meshing in StarCD	#2
HVN Guest Posts: n/a	refinement of cells near the wall?

Reply

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
can not run starcd 3.15 in windows XP?	xhliu1	CD-adapco	2	November 3, 2006 11:46
New to StarCD	Matt	CD-adapco	2	September 23, 2005 22:50
Singularity of grid?Volume meshing vs face meshing	Ken	Main CFD Forum	0	September 4, 2003 11:09
Volume Meshing & Face Meshing? singularity of grid	ken	FLUENT	0	September 4, 2003 11:08
Convert from StarCD 3.10 to StarCD 3.15	Jing	CD-adapco	1	April 17, 2002 09:22

All times are GMT -4. The time now is 05:42.