Double surface inside model

March 15, 2005, 08:04

I have a mesh built in ICEMCFD by one-layer extrusion from plain quad mesh. It contains two adjacent regions of different matherial. The verteces at the interface are the same for both blocks. But STAR-CD mesh check detects crack at the interface and the boundary tool shows two different surfaces there. Does anybody know how to repare this in ICEM or in STAR-CD? Thanks

March 15, 2005, 23:04

hi,

1. try to merge the veritecs 2. flip right handed cells 3.check for couple faliure.

tools>cell too.>check

sankar

March 15, 2005, 08:04	Double surface inside model	#1
Andrew Guest Posts: n/a	I have a mesh built in ICEMCFD by one-layer extrusion from plain quad mesh. It contains two adjacent regions of different matherial. The verteces at the interface are the same for both blocks. But STAR-CD mesh check detects crack at the interface and the boundary tool shows two different surfaces there. Does anybody know how to repare this in ICEM or in STAR-CD? Thanks

March 15, 2005, 23:04	Re: Double surface inside model	#2
sankar Guest Posts: n/a	hi, 1. try to merge the veritecs 2. flip right handed cells 3.check for couple faliure. tools>cell too.>check sankar

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Create a surface inside a volume	Michael	CFX	1	February 4, 2009 16:42
Fire model inside the domain - please help	hari	FLUENT	0	October 27, 2007 08:33
quastion about a double stream tubetube model	Eric	Main CFD Forum	0	September 2, 2006 19:47
free surface inside a stirred tank	mystic_cfd	FLUENT	5	December 11, 2002 09:27
Double the # of cells->double the computing time?	JB	Main CFD Forum	13	April 5, 2002 17:13