Home > Forums > CD-adapco

mesh error

Mark Forums Read

Reply

February 21, 2006, 06:26	mesh error	#1
Antony Guest Posts: n/a	While running a transient analysis with mioving mesh I am getting the following kind of error. Will it affect the solution. How to avoid the kind of error. WARNING #113 * CELL 10238 BEING REMOVED HAS NON-ZERO SIDE AREAS - CHECK IN PROSTAR FOR POSSIBLE MESH MOVEMENT ERROR * WARNING #113 *** CELL 10238 BEING REMOVED HAS NON-ZERO SIDE AREAS - CHECK IN PROSTAR FOR POSSIBLE MESH MOVEMENT ERROR Thanks in advance

Reply

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Error CFX Mesh	Jorn	CFX	2	August 7, 2008 10:32
MESH ERROR	Francesco - University of Florence, Italy	CFX	2	April 24, 2008 11:10
Oscillatory mesh motion setup mesh flux ERROR	jaswi	OpenFOAM Running, Solving & CFD	5	August 23, 2007 04:41
Mesh error	Vanessa	FLUENT	1	June 6, 2006 04:34
Error while exporting mesh	Vidya Raja	FLUENT	0	March 4, 2006 20:11

All times are GMT -4. The time now is 09:17.