|
[Sponsors] |
June 5, 2006, 17:17 |
Mesh error
|
#1 |
Guest
Posts: n/a
|
Hi,
Can anyone please explain what the following error in GAMBIT means: Natural source face(s) for projecting volume could not be found. I run into this error every time I try to mesh my geometry. Any help is appreciated. Thanks. |
|
June 6, 2006, 04:34 |
Re: Mesh error
|
#2 |
Guest
Posts: n/a
|
What Scheme are you using to mesh your geometry? It sounds like you using the cooper method. If so, then you need to specify the end faces as your source faces and the remainder of your faces along the sweep path need to be meshed using the map or sub-map schemes.
Hope this helps Mark |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Building OpenFOAM1.7.0 from source | ata | OpenFOAM Installation | 46 | March 6, 2022 13:21 |
c++ libraries and solver compiling | vaina74 | OpenFOAM Installation | 13 | February 3, 2012 17:43 |
[swak4Foam] groovyBC: problems compiling: "flex: not found" and "undefined reference to ..." | sega | OpenFOAM Community Contributions | 12 | February 17, 2010 09:30 |
[Netgen] Installation of Netgen in SuSE Linux 92 | edvardsenpriv | OpenFOAM Meshing & Mesh Conversion | 23 | January 16, 2009 06:12 |
Problem with compile the setParabolicInlet | ivanyao | OpenFOAM Running, Solving & CFD | 6 | September 5, 2008 20:50 |