|July 7, 2006, 08:00||
Hybrid mesh generation
I am currently modelling a car body in a drying room with pro-amm. After the successful generation of the subsurface i wanted to create a Hybrid mesh (tetra and hexahedral cells) between the outer area of the subsurface and the domainīs outer area.
I got the following error message for the hybrid mesh generation :
Recovering the surface... boundary segment can not be recovered the two points of this segment are: x1 y1 z1 and x2 y2 z2 please use the normal meshing process..
i get to this place and modified the elements but then i got the same message for another place, and so on..
Any ideas? Thanks, Fred.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Hybrid Mesh||Marc||FLUENT||4||July 18, 2007 20:38|
|Hybrid mesh generation||Jake||Main CFD Forum||2||April 21, 2007 14:27|
|when i must use the hybrid mesh ?||mike||FLUENT||1||August 25, 2006 11:16|
|hybrid mesh||Fabrizio||FLUENT||4||August 16, 2006 06:41|
|Guideline for hybrid mesh generation||Sven Schmid||Main CFD Forum||4||January 16, 2006 03:20|