|
[Sponsors] |
boundary conditions problem with mesh created in Icem |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 22, 2013, 17:39 |
boundary conditions problem with mesh created in Icem
|
#1 |
New Member
Darázs Bence
Join Date: Feb 2013
Posts: 16
Rep Power: 13 |
Hello everyone,
I have a big problem: i created a mesh in Icem and then made a cfx5 output file but after i imported this file into cfx-pre and tried to determine boundary conditions i cannot select any edges or surfaces of my geometry therefore i cannot run solver properly. Please help me. Thanks everyone in advance. |
|
Tags |
boundary, cfx-pre, conditions, icem, mesh |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
OpenFOAM 1.7.1 installation problem on OpenSUSE 11.3 | flakid | OpenFOAM Installation | 16 | December 28, 2010 08:48 |
ICEM Tetra mesh, Size reduction and Skewness problem | Catthan | ANSYS Meshing & Geometry | 6 | December 5, 2010 19:39 |
[Gmsh] Import problem | ARC | OpenFOAM Meshing & Mesh Conversion | 0 | February 27, 2010 10:56 |