|
[Sponsors] |
Error ‘The path is not of a legal form.’ in Workbench running CFX |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 29, 2015, 04:16 |
Error ‘The path is not of a legal form.’ in Workbench running CFX
|
#1 |
Senior Member
Meimei Wang
Join Date: Jul 2012
Posts: 494
Rep Power: 15 |
Hi,
I use Ansys 16.0 workbench to run CFX simulations by ‘Table of Design Points’ in ‘Parameter Set’. Here is the problem The ‘Update’ button could run the ‘DP0(Current)’ simulation normally(successfully). But when I use ‘Update All Design Points’ button, I got error information ‘Update of the Solution component in XXX for design point # failed: The path is not of a legal form.’ I think the problem shall be from the ‘Solver Input File’ path setting in ‘Run Definition’ as whether I setup an initial value or not, the error remains. The setup I did is shown in the figure attached. I tried different ‘Solver Input File’ paths, e.g. ‘…./dp0/CFX/CFX/XXX.def’ but none of them works. It seems the original default setting, which is a path to a non-relevant folder and not existing file that makes no sense, could work all things well. But how to recover to the default setting? May I ask why I got this error message and how to solve this problem?
__________________
Best regards, Meimei |
|
July 1, 2015, 05:18 |
|
#2 | |
Senior Member
Meimei Wang
Join Date: Jul 2012
Posts: 494
Rep Power: 15 |
Quote:
__________________
Best regards, Meimei |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Question about Workbench CFX error message | Anna Tian | CFX | 6 | June 21, 2014 12:13 |
Adding new fluid material in workbench and using it in cfx | nirajpandya | ANSYS | 1 | May 7, 2014 05:35 |
RSH problem for parallel running in CFX | Nicola | CFX | 5 | June 18, 2012 18:31 |
mesh from Workbench Simulation to Cfx Pre? | Dai | CFX | 6 | November 11, 2006 12:19 |
Running CFX on a cluster | jvk | CFX | 9 | September 19, 2002 22:22 |