HELP!!TWO PHASES FLOW -- CFD Online Discussion Forums

July 18, 2001, 20:49	HELP!!TWO PHASES FLOW	#1
dingding Guest Posts: n/a	Hi,everyone! I am simulating the oil-water two phases flow. I set two inlets at LOW I of a block, one is oil water inlet and another is water inlet. I use the homogeneous model to simulate the free surface between the oil and the water. The problem is that U, V, MASS and VOLUME FRACTION of each phases don't convergence, in addition, no free surface in the CFX-analyse, why? I used a single water compuation as the START dump file, but no free surface being found! Please help me! Thanks in advance.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mass flow and U-Mom flow in CFX	Zhihua Xie	CFX	0	September 3, 2007 09:49
reversed flow at velocity inlet / mass flow inlet	ib	FLUENT	1	March 26, 2007 13:11
How to change from mass flow to volume flow rate	stanley	FLUENT	1	February 2, 2007 06:44
transform navier-stokes eq. to euler-eq.	pxyz	Main CFD Forum	37	July 7, 2006 08:42
Plug Flow	Franck	Main CFD Forum	3	September 4, 2003 05:57

All times are GMT -4. The time now is 07:17.