CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > CFX

inflation

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   July 15, 2002, 19:41
Default inflation
  #1
Hannah liang
Guest
 
Posts: n/a
Hi, all cfd friends, I always have troubles when i use the inflation. the definition file could be writen when no inflation but failed if i add inflation. pls give me some advice.

Thanks a lot

Hannah

  Reply With Quote

Old   July 18, 2002, 07:55
Default Re: inflation
  #2
henry
Guest
 
Posts: n/a
hi,

you got to read the error message carfully and then hightlight the region of error ,and in that surface give appropiate mesh controls and it will be fine.

Some times you have to play with the mesh control numbers - mesh size

hope tihs solves your problem

henry
  Reply With Quote

Old   July 18, 2002, 14:19
Default Re Inflation
  #3
TheOneOnTheRight
Guest
 
Posts: n/a
Hi, quite often if you can produce a volume mesh without inflation, but can't with inflation it can be due to either two surfaces being too close together for the correct amount of layers to be included - this should be easy for you to check. It could also be due to some rogue CAD geometry which has produced a poor surface mesh, which does not allow inflation to be produced. You can use the CAD quality checker to highlight poor surfaces. Hope this helps.
  Reply With Quote

Old   July 19, 2002, 15:41
Default Re: Re Inflation
  #4
Hannah liang
Guest
 
Posts: n/a
Thanks for TheOneOnTheRight's advice. Could you tell me where I can find the CAD quality checker in the CFX 5.5

Thanks again
  Reply With Quote

Old   July 20, 2002, 14:32
Default Re: Re Inflation
  #5
TheOneOnTheRight
Guest
 
Posts: n/a
No problem, its in Build under Tools\CAD Quality Check.. It will only allow you to do this after you have completed the domains form.
  Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Total Thickness of Inflation Layer prikeyma CFX 3 February 12, 2013 04:19
Large Valve Flow Analysis - Inflation Problem sercan85 ANSYS Meshing & Geometry 2 June 1, 2010 14:02
question about inflation for impeller sandy CFX 4 August 8, 2007 09:03
Inflation Gab CFX 6 August 24, 2005 22:45
inflation Jennifer Haque CFX 2 June 9, 2004 18:55


All times are GMT -4. The time now is 14:47.