|
[Sponsors] |
July 24, 2002, 21:54 |
help with airfoil
|
#1 |
Guest
Posts: n/a
|
Hi,
I have just started using CFX5.5 and lam having a problem creating a surface for an airfoil. The problem is that l tried splitting the airfoil into two curves through the spline method to create a surface but lam getting a warning that there are two degenerate edges in the surface. Which cause problems later when meshing. Any help would be very much appreciated. Kristov |
|
July 27, 2002, 01:11 |
Re: help with airfoil
|
#2 |
Guest
Posts: n/a
|
Hi Kristov, Have a look in the meshing documentation. There's an explanation of degenerate edges in there. Michael
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Low Speed Airfoil | Mancusi | FLUENT | 7 | April 3, 2014 06:11 |
[GAMBIT] Meshing airfoil using .dat file problem | creggie | ANSYS Meshing & Geometry | 10 | June 27, 2010 19:24 |
ICEM CFD Airfoil Tutorial Input | Tom | ANSYS Meshing & Geometry | 1 | September 25, 2009 06:50 |
Modeling Backflow for a 3D Airfoil (Wing of Finite Span) | Josh | CFX | 9 | August 18, 2009 11:31 |
Airfoil boundary condition | Frank | Main CFD Forum | 1 | April 21, 2008 18:36 |