CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > CFX

Creating SOLID-REP

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   September 8, 2003, 19:25
Default Creating SOLID-REP
  #1
Lucio
Guest
 
Posts: n/a
Hi, Im having a problem to create the solid b-rep in the CFX 5.5. I am modelling a turbulence flow in a body.

It have 80 surfaces and I already made the "EDIT /SURFACE/EDGE MATCH" and too "VERIFY/SOLID/B-REP" and both are correct. When I request the "CREATE/SOLID/B-REP", the program begun to run and after a few moment,(maybe one minute) it just close without any information. Would somebody help me? How can I obtain more information about the problem? Would it be because of the hardware? I hope somebody answer's. Regards at all. Lucio
  Reply With Quote

Old   September 9, 2003, 08:30
Default Re: Creating SOLID-REP
  #2
Bob
Guest
 
Posts: n/a
HI, It shouldn't be the hardware. Does build repeatedly close when you try to create the brep again ? When viewing your surfaces, what do the display lines in build look like. You should see two vertical and two horizontal lines on each surface. Do these lines look evenly spaced (apart from on trimmed surfaces !). These lines will indicate if you have any pooly parameterised surfaces. If you do have such surfaces you may need to rebuild them. Bob
  Reply With Quote

Old   September 9, 2003, 13:08
Default Re: Creating SOLID-REP
  #3
Lucio
Guest
 
Posts: n/a
Thanks Bob Well, yes, the Build close repeatdly.. In fact I can see lines spaced from the trimmed surface. But I thought that all connection would be corrected when I did the EDGE MATCH function. Thanks for your reply. Ill try to rebuild the the body. Lucio
  Reply With Quote

Old   September 10, 2003, 19:22
Default Re: Creating SOLID-REP
  #4
Lucio
Guest
 
Posts: n/a
The modification gave results. I create the solid B-REP Thanks again, Bob. Lucio.
  Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
solid to fluid heattransfer with chtMultiRegionFoam nakor OpenFOAM 11 March 21, 2011 09:28
[GAMBIT] problems creating moving solid free ANSYS Meshing & Geometry 5 October 7, 2010 01:54
creating solid from car body surface data Mehmet Yilmaz FLUENT 1 January 16, 2008 07:57
creating a solid body in Design Modeller Dan CFX 0 May 24, 2004 11:59
CFX4.3 -build analysis form Chie Min CFX 5 July 12, 2001 23:19


All times are GMT -4. The time now is 17:17.