|
[Sponsors] |
November 4, 2003, 00:46 |
curvature sensitive meshing
|
#1 |
Guest
Posts: n/a
|
I am to simulate diffusion from a drop surface of a oil into water.the drop is irregular.i have used surface controls(angular resolution) over the the drop surface .i have to get flux at the surface .is inflated boundary necessary again on the surface. is it just enough to set surface control.(angular) soubhik
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Best Meshing scheme for Cylinder | Nutrex | Main CFD Forum | 4 | July 29, 2008 11:03 |
Meshing locks workbench window. | andy2o | CFX | 0 | February 1, 2008 05:01 |
ICEM: meshing regarding to curvature | DAK565656 | CFX | 6 | November 20, 2005 06:14 |
Singularity of grid?Volume meshing vs face meshing | Ken | Main CFD Forum | 0 | September 4, 2003 11:09 |
Volume Meshing & Face Meshing? singularity of grid | ken | FLUENT | 0 | September 4, 2003 11:08 |