|
[Sponsors] |
February 1, 2008, 05:01 |
Meshing locks workbench window.
|
#1 |
Guest
Posts: n/a
|
Hi All,
I'm using CFX 11 SP1. When I start meshing in a Workbench session, Workbench is then 'locked' onto the meshing pane until the meshing is complete ~20 min later. * Is there any way I can access DesignModeler and continue my work there whilst meshing is in progress? * Is this 'locking up' a consequence of having only one set of licenses, or does it always happen? Many thanks for your suggestions, Andy. (I'm building a rather detailed geometry in stages, and meshing it regularly to catch problems and run test calculations, so this isssue is causing me a lot of wasted time. I'm reluctant to leave all my meshing until the end because I have uncovered a lot of small errors by meshing regularly) |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Remeshing in CFX using workbench meshing. | adeban | CFX | 25 | March 29, 2021 05:46 |
ansys workbench meshing ====help | alizee | ANSYS | 3 | December 17, 2011 16:20 |
meshing with workbench | jnpmg | ANSYS Meshing & Geometry | 2 | January 31, 2011 05:57 |
[Other] Bridge meshing in Workbench (for Fluent) | Plusquamperfectum | ANSYS Meshing & Geometry | 1 | May 20, 2010 14:30 |
CFX meshing with Workbench | anna | CFX | 1 | December 19, 2006 14:35 |