|
[Sponsors] |
October 7, 2004, 17:19 |
CFX 5.7 rotational mesh deformation?
|
#1 |
Guest
Posts: n/a
|
Hi all,
I've been playing with tut 20 ... the presure relief valve. Can CFX 5.7 handle rotation of mesh cavities? E.g. smaller cube cavity rotating within larger mesh cube? In this case the geometric centre of the cavity would not translate but would rotate. TIA |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
[ANSYS Meshing] Internal gear pump mesh deformation CFX V11 | Malik77 | ANSYS Meshing & Geometry | 0 | August 22, 2011 10:22 |
cfx mesh problem... | mactech001 | ANSYS Meshing & Geometry | 0 | November 5, 2009 02:19 |
Convergence moving mesh | lr103476 | OpenFOAM Running, Solving & CFD | 30 | November 19, 2007 14:09 |
Problem with rotational mesh deformation: Part II | NymphadoraTonks | CFX | 2 | November 4, 2004 03:05 |