|
[Sponsors] |
March 21, 2005, 11:54 |
Getting started with CFX
|
#1 |
Guest
Posts: n/a
|
Hi,
I am want to solve a case for the flow across a square cylinder, and I'm just starting with CFX. This shall be an unsteady LES calculation. How can I output the drag and lift (due to pressure & shear) on the cylinder at each time step? What's the easiest way of doing this? Thanks! |
|
March 21, 2005, 16:27 |
Re: Getting started with CFX
|
#2 |
Guest
Posts: n/a
|
Hi,
You are attempting a LES simulation and you are new to CFX? That does not sound wise. LES simulations are not straight-forward. I would recommend only attempting an LES simulation when you are experienced with CFX and CFD in general. But to answer your question, you can output your lift and drag on each timestep by creating monitor points outputting a CEL expression. You can calculate overall forces on surfaces using the force_x()@surface family of functions. Glenn Horrocks |
|
March 21, 2005, 16:57 |
Re: Getting started with CFX
|
#3 |
Guest
Posts: n/a
|
Thanks for your inputs Glenn.
I am not new to CFD or LES, just new to the CFX software. Will this "force_x()@surface family of functions" give me an integral value over the surface? Or will it give a local value for the force? Thanks in advance! |
|
March 22, 2005, 14:32 |
Re: Getting started with CFX
|
#4 |
Guest
Posts: n/a
|
force_x() give integral value. See documentation. Then you can create variable and monitor it...
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ATTENTION! Reliability problems in CFX 5.7 | Joseph | CFX | 14 | April 20, 2010 15:45 |
Different flow pattern between OpenFOAM and CFX | AirS | OpenFOAM | 0 | January 12, 2010 07:08 |
heat generation in CFX | Ema | CFX | 4 | August 7, 2009 05:39 |
CFX 10's solutions differ from CFX 5.7's | Atit Koonsrisuk | CFX | 4 | July 26, 2006 11:59 |
CFX 10 in CFX 5.7 | panneerselvam.R | CFX | 6 | February 6, 2006 03:56 |