|
[Sponsors] |
June 3, 2005, 16:58 |
CFX solver command
|
#1 |
Guest
Posts: n/a
|
Hello,
1ST QUESTION: This may be a simple question but I need any advise. I am running a Rotating Frame of Ref problem with heat transfer, everything goes fine until I do mesh refinement or ask for DOUBLE PRECISION... I run out of memory, (I am already using 1.4x an I have tried higher...) then the question is where (in the online manuals) can I find the proper commands to increase the allocated memory in order to send the definition file to a more powerfull machine we have?... I have already the script file, but I will need to 'ask' for more memory stacks (integer and real). 2ND QUESTION: I am getting RMS errors of about 2e-3 and RMS peak of 2E-2 in the above type problem (that's why I made mesh refinement)... Does anyone know any paper/book that deals with convergence issues in rotating frames problems? Sorry if they're too miserable questions... I am still new in this. Best regards |
|
June 3, 2005, 20:31 |
Re: CFX solver command
|
#2 |
Guest
Posts: n/a
|
Hi Carl,
Read the warning carefully. If the solver cannot allocate enough memory, then you might want to reduce the amount of memory it is trying to allocate. Try a memory factor of 0.9 instead, or better still, run it in parallel. Regards, Robin |
|
June 4, 2005, 03:01 |
Re: CFX solver command
|
#3 |
Guest
Posts: n/a
|
Thanks for the advise, I definitively do not know enough about this... since I increased the cells number I thought more allocation was required... but it is the reverse. It is running now Robin, thanks very much.... I got antoher error but I think I can sort it out... (ERROR #002100004 has occurred in subroutine Out_Scales_Flu...) it did not stop the solution... Thanks.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
thobois class engineTopoChangerMesh error | Peter_600 | OpenFOAM | 4 | August 2, 2014 09:52 |
[ICEM] trouble with mesh quality from ICEM in CFX Solver | escher25 | ANSYS Meshing & Geometry | 0 | February 28, 2011 07:38 |
How to start CFX Solver with an existing parfile | lentschi | CFX | 3 | February 20, 2011 13:31 |
CFX solver error | kh_thakor | CFX | 3 | January 11, 2011 16:39 |
Installation OF1.5-dev | ttdtud | OpenFOAM Installation | 46 | May 5, 2009 02:32 |