 |
 |
 |
|
|
|
[Sponsors] | ||||
September 24, 2005, 12:03
|
problems of ansys icem10
|
#1 |
|
Guest
Posts: n/a
|
hi all
when i was using icem10, i found that icem10 can not load mesh from the block when hex grids arive at 6800000,would you tell me what computers can do it well, my computer is 512M memmory, |
|
|
||
|
September 24, 2005, 17:51
|
Re: problems of ansys icem10
|
#2 |
|
Guest
Posts: n/a
|
You definitely need a machine that has more than 512M memory to such a big mesh. I doubt 32-bit Windows can handle this mesh. You probably need a 64-bit Linux/Unix machine.
|
|
|
|
||
|
September 26, 2005, 09:22
|
Re: problems of ansys icem10
|
#3 |
|
Guest
Posts: n/a
|
32-bit machine will be fine - but you probably need 2 or 3 GB RAM to do this.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question How to save Ansys 13 project to be opened by ansys 12 ? | rafiktharwat | ANSYS | 3 | July 17, 2017 21:09 |
| [ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing | David-CFD | ANSYS Meshing & Geometry | 1 | April 1, 2011 05:22 |
| ansys imports icem-cfd ansys mesh | adam2008 | ANSYS Meshing & Geometry | 0 | March 5, 2011 08:40 |
| FLUENT to ANSYS Temperature Mapping Procedure | schreiberc1 | FLUENT | 0 | June 29, 2006 13:50 |
| ANSYS to acquire CFX | Fred | FLUENT | 0 | February 18, 2003 21:04 |
Linear Mode
