|
[Sponsors] |
March 5, 2011, 08:40 |
ansys imports icem-cfd ansys mesh
|
#1 |
New Member
Join Date: Jul 2009
Posts: 25
Rep Power: 17 |
hi,
I generated a tets/prism mesh in ICEM-CFD. The number of mesh is about 3.6 million and the number of element is 20 million. It is a very large mesh due to its geometry. Then I exported mesh as "structural solid linear 45" mesh for Ansys 11. However, when Ansys loaded the mesh, it always gave me the error as shown in attached and Ansys just stopped after a while due to too many the same errors. Interestingly, if I reduced the mesh to 1.4 million nodes/7.7 million elements, Ansys could successfully import the mesh and ran a structural simulation. I suspect it is because the data is too large and data is kind of misformatted leading to reading-in errors. Can any ansys/icem-cfd experts give me some ideas how to solve it? Thanks a lot! |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Icem CFD mesh grading issue | joegi.geo | ANSYS Meshing & Geometry | 7 | March 8, 2011 18:26 |
ICEM 12 CFD help creating volume mesh from stl | EmpError | ANSYS | 0 | November 13, 2010 06:38 |
ICEM CFD to CFX geometry and mesh | Luca | CFX | 6 | February 4, 2010 16:31 |
How to extrude 2D Mesh in ICEM CFD? | VSB | CFX | 7 | December 27, 2006 11:58 |
how to export mesh from ICEM CFD to Ansys | siv | CFX | 10 | March 23, 2006 08:19 |