|
[Sponsors] |
November 22, 2015, 13:56 |
CFX & Transient structural
|
#1 |
New Member
Join Date: Oct 2015
Posts: 28
Rep Power: 10 |
Hi,
I need your help, I have a plate that vibrates in a flow , The plate is created by transient structural and the flow is simulated by CFX, It is a two- way FSI. Reynolds number is based on diameter and is 100, I want to calculate the mean velocity of fluid over a plate that vibrates in a flow. In CFD Post the velocity around of the plate while the plate is oscillating is zero, Is there any one to help me? I want to the flow feels the plate but in this way the flow cant see the plate and also there is no vortex. ANSYS6.png |
|
November 22, 2015, 17:24 |
|
#2 |
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,716
Rep Power: 143 |
The no slip condition says that the flow next to the plate has a velocity of zero (relative to the plate). The solver is returning the correct value.
So you need to think up a more physically realistic parameter to measure. |
|
November 23, 2015, 14:27 |
|
#3 |
New Member
Join Date: Oct 2015
Posts: 28
Rep Power: 10 |
Thanks for your helping, So if I want to see the fluid velocity near the plate how can I simulate this case, I think this is look like a flutter, can I use Transient Structural with CFX ?
|
|
November 23, 2015, 16:01 |
|
#4 |
Senior Member
Join Date: Jun 2009
Posts: 1,811
Rep Power: 32 |
Not sure, but if you check your setup for the boundary conditions on the plate, you may find out that the mesh motion is not stationary, and you are enforcing No Slip Wall with Wall Velocity Relative to the Mesh Motion
If that is the case, you will see 0 velocity of the fluid. You may want to see then the Mesh Velocity instead. Hope the above helps |
|
November 24, 2015, 14:55 |
|
#5 | |
New Member
Join Date: Oct 2015
Posts: 28
Rep Power: 10 |
Quote:
|
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Time average results in Transient CFX Simulation | BalanceChen | CFX | 32 | September 30, 2021 13:59 |
CFX Reduce transient output file size | ThomasN | CFX | 4 | October 10, 2013 05:37 |
Static structural Analysis using temperature profile from CFX transient solution | bhavik139 | Structural Mechanics | 3 | July 7, 2013 20:51 |
Uploading CFX transient files(.trn) in to Fluent | subba | FLUENT | 0 | July 2, 2013 15:21 |
importing Pressure in Transient structural with .XML format | omidiut | CFX | 1 | December 2, 2011 16:47 |