|
[Sponsors] |
February 10, 2006, 00:09 |
coordinate in Workbench
|
#1 |
Guest
Posts: n/a
|
I am using Workbench to design the model. But I did not know how to set the coordinates of the line or circle. I only saw the x,y ordinate in table, but I cannot changed the ordinate.
For exampe, it is difficult the darw a square and a circle with the same center. Thank you for you replaying. At the same time, it is my pleasure to keep contact with you. MSN: qiuyifa@hotmail.com |
|
February 13, 2006, 18:05 |
Re: coordinate in Workbench
|
#2 |
Guest
Posts: n/a
|
Try concident geometrical constrain in scetcher
|
|
February 13, 2006, 20:48 |
Re: coordinate in Workbench
|
#3 |
Guest
Posts: n/a
|
Thank you for your help.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ANSYS Workbench on "Uncertified" Linux Distros | hsr | CFX | 289 | April 20, 2023 09:23 |
PEM Fuel cell module meshes. ICEM vs workbench | aarvay | FLUENT | 24 | March 2, 2020 06:50 |
[ANSYS Meshing] Workbench 13: Structured Hexa Meshes | rooftop | ANSYS Meshing & Geometry | 19 | March 31, 2016 02:33 |
cylindrical coordinate vs cartesian coordinate | Lam | FLUENT | 10 | May 11, 2013 13:05 |
Cording Ground.for in Cylindrical coordinate | J.H. Lee. | Phoenics | 2 | March 28, 2003 04:28 |