CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > CFX

Solver scheme

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   March 7, 2006, 14:03
Default Solver scheme
  #1
Richard
Guest
 
Posts: n/a
Hi, I am trying to transfer a stimulation done using turbogrid and tscflow into CFX 5.7.1 (the one with the workbench). what scheme should i use in CFX pre that is equivalent to Modified Linear Profile and Physical Advection Correction of TascFlow. And the parameter use in TASC is 500 time step, of residual convergence of 10^-3. And fluid time step=0.005, what should I use in CFX pre?
  Reply With Quote

Old   March 7, 2006, 14:10
Default Re: Solver scheme
  #2
Robin
Guest
 
Posts: n/a
Hi Richard,

CFX has no direct equivalent to the Modified Linear Profile + PAC advection scheme. The closest would be to run with a specified blend factor of 0.75. However, you should get better results with the default "High Resolution" scheme. All your other parameters have direct equivalents in CFX (use MAX residual rather than RMS, MAX was the default in TASCflow).

Regards, Robin
  Reply With Quote

Old   March 9, 2006, 09:55
Default Re: Solver scheme
  #3
Richard
Guest
 
Posts: n/a
Thank,really appreciate your advice. i really rushing for time to hand in my report.Pls help

First i am stimulating a pump. Therefore i use extrude to create a enclose area around the pump an cut the mat'l out, leaving behind a part with hole that take the shape of the pump inside

Then i spilt up the pump into stationary and rotating part, and use frozen rotor for the interface for them.I also create 2 cylindrical area, one as inlet flow area, another as outlet and use frozen rotor for their interface with the pump domain. I use mass flow rate for inlet and static pressure(refeence 0) for outlet.

I run this simulation for a different flow rate but get almost the same static pressure gen across the pump. How come? Inaddition there is high velocity found in at the interface.
  Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
smoothSolver diverges - solution in using PBiCG solver? makaveli_lcf OpenFOAM Running, Solving & CFD 3 September 11, 2013 12:44
different results between serial solver and parallel solver wlt_1985 FLUENT 10 April 11, 2012 15:25
Question about the MIGAL solver bearcat Phoenics 0 February 4, 2010 19:02
Getting too many iterations by velocity solving (aborting). Changing U - Solver? suitup OpenFOAM Running, Solving & CFD 0 January 20, 2010 08:45
Poisson Solver or suitable scheme Tingting Main CFD Forum 1 August 4, 2006 06:47


All times are GMT -4. The time now is 14:11.