|
[Sponsors] |
March 15, 2006, 07:36 |
how to check qlty of mesh?????
|
#1 |
Guest
Posts: n/a
|
Hello friends my question is how to check quality of mesh generated using CFX? PLZ reply.
|
|
March 15, 2006, 12:17 |
Re: how to check qlty of mesh?????
|
#2 |
Guest
Posts: n/a
|
Make your mesh finer. If you get the same results it was good to start with. If you get different results, it's not good.
Also check your Wall Scale. Do the "Flow Around a Blunt Body" tutorial, it will give you an idea! /C |
|
March 15, 2006, 19:40 |
Re: how to check qlty of mesh?????
|
#3 |
Guest
Posts: n/a
|
Use CFX-post to verify the mesh quality.Plot y+ and have a look. make sure your meash is even. Goodluck, Rajit
|
|
March 15, 2006, 23:33 |
Re: how to check qlty of mesh?????
|
#4 |
Guest
Posts: n/a
|
thank you, i will try.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
3D Hybrid Mesh Errors | DarrenC | ANSYS Meshing & Geometry | 11 | August 5, 2013 06:42 |
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |
OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found | piprus | OpenFOAM Installation | 22 | February 25, 2010 13:43 |
[snappyHexMesh] external flow with snappyHexMesh | chelvistero | OpenFOAM Meshing & Mesh Conversion | 11 | January 15, 2010 19:43 |
Problems in compiling paraview in Suse 10.3 platform | chiven | OpenFOAM Installation | 3 | December 1, 2009 07:21 |