[satyendra]

hi all,

i am doing analysis of a furnace in fluent 6.3(geometry modeled in gambit 2.24). i have made structured mesh in most of the volume except at the corners of the mould.

initially when the hot gases' velocity were low it was converging, but i was not getting required temperature inside mould. hence i increased the flow rate without changing the model.

But now except energy, all other residuals i.e continuity, k, x, y, z velocity and epsilon are fluctuating. following are the specs:
1. unsteady flow.
2. turbulent k-epsilon and RNG model
3. time step = 1

satyendra