|
[Sponsors] |
May 23, 2006, 08:33 |
Problem help!!!!!!!
|
#1 |
Guest
Posts: n/a
|
Hi friends..I am simulating the flow over a wedge shaped body using Ansys-CFX. The flow over the wedge is being Hypersonic(M5.75). I am neglecting viscous terms in the energy equation. I made the as blunt body with nose radii of 20, 40, 60, 80 mm one after the other. Now I was expecting the temperature on the surface of the wedge with sharp tip should be more than any other geometry. WHAT I HAVE TO COMPARE IN ORDER TO CONCLUDE THAT, BLUNT BODIES WILL EXPERIENCE LESS HEAT THAN SHARP TIP WEDGE BODIES??? Plz help me. Regards VVJ.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
UDF compiling problem | Wouter | Fluent UDF and Scheme Programming | 6 | June 6, 2012 04:43 |
Gambit - meshing over airfoil wrapping (?) problem | JFDC | FLUENT | 1 | July 11, 2011 05:59 |
natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 06:29 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
Is this problem well posed? | Thomas P. Abraham | Main CFD Forum | 5 | September 8, 1999 14:52 |