Home > Forums > CFX

self intersecting (mesh volume)

Mark Forums Read

Reply

May 30, 2007, 18:55	self intersecting (mesh volume)	#1
Eko Guest Posts: n/a	I was generated twin propeller in CFX 5. but when it have been volume meshing, it became error (self intersecting its surface). I was reduced mesh control, edge match every surface, and use line method in meshing surface (before i used surface method) but it no longer work. Can anybody help me??

Reply

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Moving mesh	Niklas Wikstrom (Wikstrom)	OpenFOAM Running, Solving & CFD	121	March 7, 2013 17:21
2D Mesh Generation Tutorial for GMSH	aeroslacker	Open Source Meshers: Gmsh, Netgen, CGNS, ...	12	January 19, 2012 03:52
Mesh motion with Translation & Rotation	Doginal	CFX	0	August 3, 2011 16:37
[ICEM] Growing prism mesh without volume mesh and with a symmetry plane	adenlan	ANSYS Meshing & Geometry	0	June 14, 2011 03:53
BlockMesh FOAM warning	gaottino	OpenFOAM Native Meshers: blockMesh	7	July 19, 2010 14:11

All times are GMT -4. The time now is 14:51.