|
[Sponsors] |
November 20, 2008, 10:57 |
Work bench design modleler
|
#1 |
Guest
Posts: n/a
|
Hi,
I am trying to extrude (add matreial) a face normally in Workbench design modeler. The face is from another extrude (cut) operation. So I used NamedSelection but can not set the direction vector. Its none(normal) in the detail view. So giving invalid direction vector after generation. Any suggestion ? Regards Faruk |
|
November 21, 2008, 13:59 |
Re: Work bench design modleler
|
#2 |
Guest
Posts: n/a
|
you have to select an edge (indicating normal vector) to extrude from a face. The edge must be there.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Heat exchanger design | sakthi | Main CFD Forum | 6 | September 3, 2022 01:22 |
[Other] Connecting 3D bodies in Ansys Design Modeler | chipper | ANSYS Meshing & Geometry | 4 | January 25, 2018 09:45 |
Design Integration with CFD? | John C. Chien | Main CFD Forum | 19 | May 17, 2001 15:56 |
Info: Short Course On Thermal Design of Electronic Equipment | Arnold Free | Main CFD Forum | 0 | August 10, 1999 10:18 |
Yacht Design and CDF | Astrid Barros | Main CFD Forum | 2 | August 25, 1998 14:18 |