|
[Sponsors] |
October 20, 2010, 10:44 |
Using stage interface
|
#1 |
Member
Join Date: Apr 2010
Posts: 33
Rep Power: 16 |
Dear all,
My question is regarding the use of a stage interface. I am modelling a fan blowing air through a radiator. Is it valid to model one fan passage out of seven and the entire radiator and to use a stage interface between the two? The radiator is square. In other words do I need to model the full fan for this case? I am considering using the downstream velocity constraint "constant total pressure" so that the downstream velcoity can be adjusted due to the impact of the radiator. Thanks, ijk |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
Questions about STAGE interface | pad | CFX | 3 | April 28, 2010 09:08 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
Stage Interface Without Frame Change | Vikram | CFX | 2 | October 21, 2005 04:55 |
Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 20:09 |