|December 14, 2011, 14:11||
Initial conditions in sedimentation tank
Javier Climent Agustina
Join Date: Nov 2011
Posts: 7Rep Power: 6
Dear members of forum,
Iím modeling a simple secondary sedimentation tank where particles settle onto the bottom of a tank. Iíve defined the problem as a particle transport solid option and water as a continuous fluid. Before running, Iíve consider two issues about initial conditions, here my doubt:
1. * Should I run the problem firstly only with continuous fluid until it would converge and after introduce the particles?
2. * How can I define initial conditions in order to perform that before entering the first particles, old particles are previously in the tank?
Thanks, any information could help me
|Thread||Thread Starter||Forum||Replies||Last Post|
|transsonic nozzle with rhoSimpleFoam||Unseen||OpenFOAM Running, Solving & CFD||7||April 16, 2014 03:38|
|How to write k and epsilon before the abnormal end||xiuying||OpenFOAM Running, Solving & CFD||8||August 27, 2013 15:33|
|alphaEqn.H in twoPhaseEulerFoam||cheng1988sjtu||OpenFOAM Bugs||14||September 18, 2011 13:46|
|Full pipe 3D using icoFoam||cyberbrain||OpenFOAM||4||March 16, 2011 10:20|
|Negative value of k causing simulation to stop||velan||OpenFOAM Running, Solving & CFD||1||October 17, 2008 05:36|