CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > CFX

CFX-Pre / Turbo Mode Error

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   April 13, 2012, 15:44
Default CFX-Pre / Turbo Mode Error
  #1
New Member
 
Jason
Join Date: Apr 2012
Posts: 1
Rep Power: 0
Bourne is on a distinguished road
I am having problems with the Turbo-Mode in CFX-Pre.

Background: Using a sector model of a centrifugal compressor impeller with one main blade and one splitter. This is an 18 blade impeller so I am using a 40deg sector of the impeller with periodic BC's

Problem: I use turbo-mode for my set up and set # of passages per mesh & model to 1, with a total of 9 "pie slices" for a full 360deg impeller. I save turbo mode and go back to the general set up to change my turbulence model. At this point I have no errors. I save and go back to workbench, I am running the solver from workbench so I can send a few studies to the RSM queue and run a few things overnight. If I run it immediately everything works fine. The issue is when the next runs starts, as the CFX-pre file gets updated before the solver starts I get the below error messages.

Error Messages: Value of 'Number of Passages in Component' is set to '0' with a minimum setting of '1'.

When I go back into turbo-mode my # of pasages is still set to '1' and as long as I click on each domain (not changing any values) in that screen and save turbo-mode the error seems to disappear until the CFX setup block is updated in workbench.

I can workaround this by running the solver and CFX-pre from the CFX launcher so the issue seems to be with workbench.

Any thoughts on this issue?
Attached Images
File Type: jpg CFX Pre Error.jpg (95.9 KB, 27 views)
File Type: jpg Turbo Mode Sutup.jpg (93.3 KB, 25 views)
File Type: jpg workbench error.jpg (92.3 KB, 20 views)

Last edited by Bourne; April 13, 2012 at 15:50. Reason: fixed attachements
Bourne is offline   Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Undeclared Identifier Errof UDF SteveGoat Fluent UDF and Scheme Programming 7 October 15, 2014 07:11
Building OpenFOAM1.7.0 from source ata OpenFOAM Installation 42 May 14, 2012 20:48
ParaView for OF-1.6-ext Chrisi1984 OpenFOAM Installation 0 December 31, 2010 07:42
Installation OF1.5-dev ttdtud OpenFOAM Installation 46 May 5, 2009 02:32
Problem with compile the setParabolicInlet ivanyao OpenFOAM Running, Solving & CFD 6 September 5, 2008 20:50


All times are GMT -4. The time now is 14:55.