|
[Sponsors] |
How to set the values of a special area at every time step? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 2, 2011, 00:16 |
How to set the values of a special area at every time step?
|
#1 |
New Member
davidyin
Join Date: Nov 2011
Posts: 4
Rep Power: 14 |
Hi, boys and girls,
With VOF method, A UDS was adopted to simulate the distribution of a material under water and air twophases flow. The concentration of the material in A area will vary with time.The concentration of the material in B area will not vary and be a constant. And the interface between A area and B area will vary, but can be traced by air or water volume ratio. my question is how to write the code to set the concentration of the material in B area as the constant at every timestep.Please see the attachment. Thanks a lot! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to show the transient case? | H.P.LIU | Phoenics | 7 | July 13, 2010 04:31 |
Time step in transient simulation | shib | FLUENT | 0 | June 17, 2010 13:07 |
Navier-Stokes time step size | Martin | Main CFD Forum | 2 | June 6, 2008 03:38 |
CFX Solver Memory Error | mike | CFX | 1 | March 19, 2008 07:22 |
IcoFoam parallel woes | msrinath80 | OpenFOAM Running, Solving & CFD | 9 | July 22, 2007 02:58 |