|
[Sponsors] |
April 23, 2012, 05:44 |
Size-change
|
#1 |
New Member
Marco
Join Date: Apr 2011
Posts: 9
Rep Power: 15 |
Dear all,
I would like to hear your opinion about size-change mesh quality using TGrid in hybrid (prisms+tet) meshes for external/internal aerodynamics problems. It has, of course, a certain impact on the convergence behaviour of the solution. In particular, what maximum size-change value would you rate to be OK for your simulations? The problem is very likely to happen when transitioning from prisms to tets. Regards, R. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to change turbulence model in InterFoam | Gildeh | OpenFOAM Running, Solving & CFD | 4 | March 28, 2012 12:04 |
[Gmsh] discretizer - gmshToFoam | Andyjoe | OpenFOAM Meshing & Mesh Conversion | 13 | March 14, 2012 04:35 |
OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found | piprus | OpenFOAM Installation | 22 | February 25, 2010 13:43 |
Problems in compiling paraview in Suse 10.3 platform | chiven | OpenFOAM Installation | 3 | December 1, 2009 07:21 |
[Commercial meshers] ST_Malloc: out of memory.malloc_storage: unable to malloc Velocity SA, | cfdproject | OpenFOAM Meshing & Mesh Conversion | 0 | April 14, 2009 15:45 |