 |
 |
 |
|
|
|
[Sponsors] | ||||
April 19, 2013, 12:14
|
Define another cell zone
|
#1 |
|
New Member
sheikh
Join Date: Apr 2013
Posts: 16
Rep Power: 13  |
I am modelling a gas water heater for my FYP so i have do analysis on ansys 14.0. I have constructed the body and even the mesh, but unfortunately when i go into fluent it only give me a single option of cell zone conditions where as my geometry is of 2 concentric pipes, one with flue gases and other of water. Please help me in this regard. how can i separate the cell zone and define 2 different zones, one for each tubes?
|
|
|
|
|
|
April 19, 2013, 12:47
|
|
#2 |
|
Member
venki
Join Date: May 2011
Posts: 84
Rep Power: 14 |
In wch software u did meshing.?
|
|
|
|
|
|
|
April 19, 2013, 15:14
|
|
#3 |
|
New Member
sheikh
Join Date: Apr 2013
Posts: 16
Rep Power: 13 |
i did meshing in ansys 14.0 build in meshing programme.
|
|
|
|
|
|
|
April 20, 2013, 03:20
|
|
#4 |
|
Member
venki
Join Date: May 2011
Posts: 84
Rep Power: 14 |
You can split mesh in fluent also..check in tutorial
|
|
|
|
|
|
|
April 20, 2013, 06:18
|
|
#5 |
|
New Member
sheikh
Join Date: Apr 2013
Posts: 16
Rep Power: 13 |
thanks, can you provide me the link to the tutorial..?
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| FLUENT porous zone inputs | eishinsnsayshin | FLUENT | 19 | April 17, 2020 04:40 |
| [Other] How do you define a cell zone or region for porous? | bigbang | OpenFOAM Meshing & Mesh Conversion | 6 | March 18, 2016 17:42 |
| [GAMBIT] periodic faces not matching | Aadhavan | ANSYS Meshing & Geometry | 6 | August 31, 2013 11:25 |
| [Commercial meshers] fluentMeshToFoam multidomain mesh conversion problem | Attesz | OpenFOAM Meshing & Mesh Conversion | 12 | May 2, 2013 10:52 |
| UDF FOR UNSTEADY TIME STEP | mayur | FLUENT | 3 | August 9, 2006 10:19 |
Linear Mode
