Define another cell zone

billue123 · April 19, 2013, 13:14

I am modelling a gas water heater for my FYP so i have do analysis on ansys 14.0. I have constructed the body and even the mesh, but unfortunately when i go into fluent it only give me a single option of cell zone conditions where as my geometry is of 2 concentric pipes, one with flue gases and other of water. Please help me in this regard. how can i separate the cell zone and define 2 different zones, one for each tubes?

venkateshaero · April 19, 2013, 13:47

In wch software u did meshing.?

billue123 · April 19, 2013, 16:14

i did meshing in ansys 14.0 build in meshing programme.

venkateshaero · April 20, 2013, 04:20

You can split mesh in fluent also..check in tutorial

billue123 · April 20, 2013, 07:18

thanks, can you provide me the link to the tutorial..?

venkateshaero · April 20, 2013, 16:27

1.jpg
2.jpg

April 19, 2013, 13:14	Define another cell zone	#1
billue123 New Member sheikh Join Date: Apr 2013 Posts: 16 Rep Power: 14	I am modelling a gas water heater for my FYP so i have do analysis on ansys 14.0. I have constructed the body and even the mesh, but unfortunately when i go into fluent it only give me a single option of cell zone conditions where as my geometry is of 2 concentric pipes, one with flue gases and other of water. Please help me in this regard. how can i separate the cell zone and define 2 different zones, one for each tubes?

April 20, 2013, 16:27	Please refore screen shot	#6
venkateshaero Member venki Join Date: May 2011 Posts: 84 Rep Power: 16	1.jpg 2.jpg

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
FLUENT porous zone inputs	eishinsnsayshin	FLUENT	19	April 17, 2020 05:40
[Other] How do you define a cell zone or region for porous?	bigbang	OpenFOAM Meshing & Mesh Conversion	6	March 18, 2016 18:42
[GAMBIT] periodic faces not matching	Aadhavan	ANSYS Meshing & Geometry	6	August 31, 2013 12:25
[Commercial meshers] fluentMeshToFoam multidomain mesh conversion problem	Attesz	OpenFOAM Meshing & Mesh Conversion	12	May 2, 2013 11:52
UDF FOR UNSTEADY TIME STEP	mayur	FLUENT	3	August 9, 2006 11:19

April 19, 2013, 13:47		#2
venkateshaero Member venki Join Date: May 2011 Posts: 84 Rep Power: 16	In wch software u did meshing.?

April 19, 2013, 16:14		#3
billue123 New Member sheikh Join Date: Apr 2013 Posts: 16 Rep Power: 14	i did meshing in ansys 14.0 build in meshing programme.

April 20, 2013, 04:20		#4
venkateshaero Member venki Join Date: May 2011 Posts: 84 Rep Power: 16	You can split mesh in fluent also..check in tutorial

April 20, 2013, 07:18		#5
billue123 New Member sheikh Join Date: Apr 2013 Posts: 16 Rep Power: 14	thanks, can you provide me the link to the tutorial..?