|
[Sponsors] |
February 18, 2002, 08:58 |
periodic flows
|
#1 |
Guest
Posts: n/a
|
can periodic flows be used to model angled vanes? I have a tube which contains 12 angled vanes which are used to create swirl. Can I model a 1/12 segment of the cylinder and set the segment planes as periodic boundaries. The fluent manual says that for periodic flows the geometry must be translationally periodic. I would describe the situation as rotationaly periodic, does this matter?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Symmetry and Periodic boundary conditions | CFD_Fluent_User | FLUENT | 1 | October 16, 2014 02:18 |
problem about periodic boundary condition in Fluent | winnawinna | FLUENT | 0 | December 28, 2010 23:32 |
[ICEM] Specifying Periodic Vertices Causes Mesh Overlap | Josh | ANSYS Meshing & Geometry | 10 | July 8, 2010 02:39 |
under relaxation & Periodic Flows | Ardalan | Main CFD Forum | 4 | April 18, 2010 00:43 |
periodic flows and heat transfer? | scarecrow | FLUENT | 3 | December 2, 2003 00:59 |