|
[Sponsors] |
fluent shows that the the interface zone overlap |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 3, 2013, 05:18 |
fluent shows that the the interface zone overlap
|
#1 |
Member
aysiyi
Join Date: Nov 2012
Posts: 40
Rep Power: 13 |
hi
everyone . I was simulationg a centrifugal fan ,and i decompose the fan into threeparts: the inlet zone ,the blade zone and the volute zone ,and the zones were connected with interface. when i initialize my case ,fluent show the warning message: Info: Interface zones overlap for mesh interface in2. This could adversely affect your solution. can somebody tell what i shroud do ? or what the message means ? thanks! |
|
Tags |
fluent, interface, overlap |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] fluentMeshToFoam multidomain mesh conversion problem | Attesz | OpenFOAM Meshing & Mesh Conversion | 12 | May 2, 2013 10:52 |
Reference zone in Fluent | akash | FLUENT | 1 | March 13, 2013 16:39 |
How to set the interface in Fluent? | akash | FLUENT | 0 | February 4, 2013 03:39 |
Porosity profile, dividing a zone, or getting zone location from zone | khoopes | FLUENT | 0 | June 2, 2012 19:39 |
Fluent incident radiation problem | Michael Schwarz | Main CFD Forum | 0 | October 21, 1999 05:56 |