|October 1, 2013, 15:00||
Join Date: Sep 2013
Posts: 3Rep Power: 5
I am working on a "vortex induced vibrations" model. Actually I have two beams which are vibrating beside each other in the X direction.
I am simulating this model in ansys fluent as a 2D model with :
-1 velocity inlet
-2 boundary layer called 'moving_fluid' (Hybrid meshing which is moving with my plate)
-1 enclosure called "fluid"
I have written a UDF for the dynamic meshing which is working perfectly for 1 plate and let the displacement of my beams on the X (longitudinal) direction with a stiffness 'k'
However as soon as I try to simulate my model with 2 plates, 2 different issues appear :
1/ If I let a space between my two 'moving_fluid' zones, it will be too small and the dynamic meshing cannot work for some velocities
2/ If I want to bond my 2 'Moving_fluid' zones and create a sliding mesh (look at the following picture), I have an overlapping issue which appears because I give the same name to two different entities..
I have no idea how I can resolve this issue. I want my two plates moving independently from each other but for the moment it is impossible..
I am stuck on that problem for 2 days now so I would really appreciate if somebody could help me with that. Is there any tutorial ?
Thanks for helping,
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ANSYS Meshing] Can I use ANSYS Meshing for manual meshing?||Kirjain||ANSYS Meshing & Geometry||6||November 30, 2015 09:11|
|Meshing locks workbench window.||andy2o||CFX||0||February 1, 2008 06:01|
|Singularity of grid?Volume meshing vs face meshing||Ken||Main CFD Forum||0||September 4, 2003 11:09|
|Volume Meshing & Face Meshing? singularity of grid||ken||FLUENT||0||September 4, 2003 11:08|
|Sliding meshes and meshing||Joel||CD-adapco||0||September 9, 2002 06:35|