|October 15, 2013, 10:04||
3D fluent analysis
Join Date: Aug 2013
Posts: 36Rep Power: 4
I am working in a 3D wind rotor,modelled it in creo 2.0 and imported it to design modeller to draw the enclosure.I enclosed the rotor within a cylinder which again enclosed within a cuboid to give the boco's.
I did meshing in ansys mesh itself...but when I exported to fluent...it is not taxing the file,showing error as:
"Model information is incompatible with the incoming mesh"
I think it has got some problem with named selection...but I am totally blank regarding what could be done.
Plz I need help....thnx in advance.
|Thread||Thread Starter||Forum||Replies||Last Post|
|convergence in transient analysis using FLUENT||sumeet kotak||FLUENT||19||September 21, 2014 06:45|
|looking for a smart interface matlab fluent||chary||FLUENT||8||July 2, 2014 07:14|
|3D fluent analysis||SHIKHA BHUYAN||ANSYS||1||November 22, 2013 22:16|
|CFX vs. Fluent for coupling analysis||aspirany||CFX||3||January 21, 2010 00:25|
|How does FLUENT fair in absolute heat transfer analysis||Steve Aboagye||Main CFD Forum||1||August 31, 1998 12:12|