|November 5, 2013, 17:00||
Multiphase modelling using Fluent VOF
Join Date: Oct 2013
Posts: 1Rep Power: 0
Hi everyone, I'm trying to simulate the flow around ship and I use multiphase flow VOF in FLUENT for analize this type of problem.
At first I have realized the mesh in Gambit.
My problem is how to set the parameters in Fluent 14.
I did the follow commands but you can see the results in figure....
1) import the gambit mesh
2) set a steady solver
3) set the VOF model - two phases - implicit scheme
4) set the model viscous k-epsilon (2eq)
5) define materials
6) define phases
7) define operating conditions (fig) - gravity - and specified operating density
8) I set the position of the water when the simulation start (adapt region)
9) Solution methods
Pressure-velocity coupling: coupled
coupled with volume fractions
Gradient:Least Squares cell based
Pressure: body force weighted
Momentum: first order upwind
Volume Fraction: first order upwind
10) Initialize solution from all zones
The problem is about the interface how you can see in the figure.
What can I do?? What type of setting is required??
thanks a lot Sanit
|Thread||Thread Starter||Forum||Replies||Last Post|
|Problem in using parallel process in fluent 14||Tleja||FLUENT||3||September 13, 2013 10:54|
|problem in using parallel process in fluent 14||aydinkabir88||FLUENT||1||July 10, 2013 02:00|
|Multiphase modelling using Fluent VOF: Solver settings||akash||FLUENT||0||February 22, 2013 07:29|
|Problem with VOF in fluent||ash-khan||FLUENT||2||November 3, 2009 03:00|
|multiphase flow, CFX or FLUENT?||luis||Main CFD Forum||6||October 5, 2006 13:24|