 |
 |
 |
|
|
|
[Sponsors] | ||||
February 13, 2014, 19:30
|
Export ASCII file
|
#1 |
|
New Member
Muhammad Aqib Chishty
Join Date: May 2013
Location: Islamabad, Pakistan
Posts: 23
Rep Power: 0   |
Hello everyone,
I have FLUENT data file which contains all the x,y, u, v, a lot of variables you know that. I need to write a ASCII file which contains my desire parameters for each time steps. I have 120 files so that's why I want some automated function which write ASCII file in column vice for me. Is it possible? Hope you get my question. Regards: MAC |
|
|
|
|
|
February 22, 2014, 18:28
|
|
#2 |
|
Senior Member
|
Consider the following matlab script(you need to rename it in .m format):
http://www.cfd-online.com/Forums/att...-scriptflu.txt |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to calculate mass flow rate on patches and summation of that during the run? | immortality | OpenFOAM Post-Processing | 104 | February 16, 2021 08:46 |
| what is swap4foam ?? | AB08 | OpenFOAM | 28 | February 2, 2016 01:22 |
| patch error OF v2.2.2 mac | hewei | OpenFOAM Installation | 4 | November 30, 2013 16:55 |
| friction forces icoFoam | ofslcm | OpenFOAM | 3 | April 7, 2012 10:57 |
| [blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 09:56 |
Linear Mode
