|
[Sponsors] |
May 1, 2019, 11:42 |
Material assignment to an imported geometry
|
#1 |
New Member
SUMAN DEY
Join Date: Apr 2019
Posts: 1
Rep Power: 0 |
I am performing an analysis in Fluent. I have a .CATPART design which needs to be imported in Fluent for CFD analysis. Once I import the geometry and mesh it , the whole meshing is done successfully but the tick mark on the Mesh module in workbench is not showing. A material assignment inside the geometry tree is shown which according to me should not be shown during meshing. How to solve this problem?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Adding material to CFX material library | marlon | CFX | 2 | October 16, 2016 09:33 |
Connect imported geometry from solidworks | nickg54 | ANSYS | 0 | October 12, 2015 17:15 |
Ansys workbench material assignment problem. | abhi_ansys | ANSYS | 0 | April 10, 2015 07:06 |
[ICEM] Imported geometry in Solidworks (CATPart) for ICEM meshing | lcaBR | ANSYS Meshing & Geometry | 1 | March 10, 2014 05:34 |
error message | cuteapathy | CFX | 14 | March 20, 2012 06:45 |