|
[Sponsors] |
April 21, 2015, 04:23 |
mesh motion problem in open channel flow
|
#1 |
New Member
matteo
Join Date: Feb 2015
Posts: 4
Rep Power: 11 |
Hi all!
I'm simulating a water wheel with open channel flow in transient mode. At the beginning the area of the wheel is stopped and when the fluid hits the wheel I activated the mesh motion. I create the interface between the moving and stationary zone.The problem is that when the wheel starts to spin, the area that is moving is detached from the rest of the channel, as you can see from the images. I create the pattern in Solidworks, where the center of the Cartesian system matches with the center of the wheel. When I import the pattern in ansys, the center of the wheel is moved from the axis of 1,6e-11 m in X and -0,45 e-11 m in Y. Someone can help me? Thx |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[swak4Foam] funkyDoCalc with OF2.3 massflow | NiFl | OpenFOAM Community Contributions | 14 | November 25, 2020 03:30 |
Boundary condition problem for open channel flow | Andy | CFX | 9 | June 11, 2016 07:20 |
mesh problem in flow region near thin structure... | mytruth7 | FLUENT | 4 | December 15, 2013 21:54 |
Open channel flow with submerged outlet | Fonta | Fluent Multiphase | 0 | September 30, 2013 08:04 |
VOF modelling open channel river flow | Matthew Roberts | FLUENT | 6 | July 31, 2009 12:52 |