|
[Sponsors] |
June 28, 2016, 23:16 |
multiphase setting problem
|
#1 |
New Member
Yu-Hsuan Yeh
Join Date: Nov 2015
Posts: 2
Rep Power: 0 |
Hello everyone,
I use fluent to simulate a heterogeneous reaction in fixed bed reacter, so i choose multiphase model. In this case, the geometry is 2D. The reaction formula is 4/3Fe2O3(s) + CH4(g) → 1CO2(g)+ 2H2O(g)+ 8/3Fe(s) My question is how to make Fe2O3 fix in the geometry. best regards! |
|
October 20, 2016, 08:43 |
|
#2 |
Senior Member
Join Date: Jun 2014
Location: Taiwan
Posts: 100
Rep Power: 11 |
Hi~
What do you mean by "make Fe2O3 fix in the geometry" ? Is it spread on a surface? Or is it like powder? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem? with Installation of OpenFOAM 2.1.0 on to Ubuntu 10.4.4 VirtualBox | Stubby | OpenFOAM Installation | 8 | March 5, 2012 15:12 |
Multiphase Problem | Kelsuis | FLUENT | 3 | January 28, 2010 02:43 |
mass balance problem in multiphase model | mdsanij1 | FLUENT | 0 | July 28, 2009 16:01 |
Multiphase radiation in Ansys 10 problem | Luk | CFX | 2 | June 5, 2008 11:31 |
CF4 - need advice on setting up multiphase problem | Brett Towler | CFX | 2 | August 18, 2000 16:38 |