|
[Sponsors] |
December 29, 2000, 07:33 |
Result is not correct
|
#1 |
Guest
Posts: n/a
|
Dear all:
I met the problem in my project. In my case, the coaxial fuel/air burner is equipped in the axial of industrial furnace. I used the k-eps turbulent model and finite-rate/eddy-dissipation combustion model. The result is seemed in satisfactory. However, when I added DTRM radiation model, the result is crazy. The temperature distribution in centreline is higher than the result without radiation model. I didn't find the problem in the definition of my case. The grid is generated in Fluent4.5 and the case is carried out in Fluent 5.4. Any advice is welcome. Thanks lot. Li |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
Read Result Files or User Defined Result | Aquilaris | ANSYS | 0 | February 9, 2011 05:25 |
how to make sure the simulation result is correct? | sham81 | CFX | 3 | March 22, 2004 16:41 |
how to ensure that your modelling is correct | rvndr | Main CFD Forum | 7 | March 1, 2004 12:21 |
Can the correct result be obtained? | H.P.LIU | Phoenics | 0 | April 10, 2001 09:05 |